Skip to content

ULTRA PUNCH MAN - Repaired Rock

Did you 3D print this model?

Maker
3D Model

Make's Description

See print settings for file.

This model has negative overhangs in blind locations, you cannot avoid supporting it against itself. To mitigate this, I've used some weird but functional bracing settings to make sure the self-support points snap away very easily using an exacto knife reaching into the blind areas.

Areas such as, under the head, between the cape and body there are many islands, etc.

This was my 1st print of this, the dual Sigils are included because the inverted one prints the joining geometry better, but the upright one overall comes out better, you decide which to use.

Chitubox file inclued.

Other makes from the same 3D model


Add a comment