Skip to content

Surprise Egg #6 - Tiny Jet Fighter

Make's quality: 5.0/5 (1 vote)
Evaluation of members on the quality of 3D print, material, post-processing, photo, etc.
3D Model

Make's Description

Fun model!

I printed this using dual extrusion so I could set it up as one print job and have both pieces in their own color. The jet printed first and then I had the egg print on the back of the plate. For the egg I used a wide skirt to prime the extruder since that one had been waiting while the jet printed.

I did use a little support on the bottom of the egg, but that may not have been needed. I did find that I needed to use a raft for the jet to help it stick better.

I printed at 100% scale.
0.15 mm layer height for Jet and 0.2 mm for Egg.

  • Infill: 15 %

Other makes from the same 3D model

Add a comment