Skip to content

Surprise Egg #6 - Tiny Jet Fighter

Did you 3D print this model?

Maker
3D Model

Make's Description

Used CURA as the slicer. Egg and Plane base was started on high temp tape. Plane finish was good. Egg finish was good but when I opened it to place plane inside the hinge's broke.

3D Printer

CR-10

Filament

CCTREE PLA 1.75
  • Raft: No
  • Resolution: 0.01 mm
  • Temperature: 200 °C
  • Support: No
  • Infill: 25 %
  • Speed: 60 mm/s

Add a comment

2 comments

Thank you. I will do another egg using raft.

I found that the hinge tends to fuse together if printed directly on the bed. Once I added a raft it worked perfectly every time. I did the version w/ the excavator and again a raft helped.