Skip to content


Make's quality: 0.0/5 (0 votes)
Evaluation of members on the quality of 3D print, material, post-processing, photo, etc.
3D Model

Make's Description

Lovely model by Yehia, thank you for sharing this model in the community!

I have printed this model in Fillamentum light ivory PLA. And have used a 0.25mm layer height. My printspeed was 30mm/s. And i have used 18% infill. I did use a skirt. I was printing with a 0.4mm nozzle on 210 degrees Celcius. I have used Cura for slicing.

  • Raft: No
  • Resolution: 0.25 mm
  • Temperature: 210 °C
  • Support: No
  • Infill: 18 %
  • Speed: 30 mm/s

Other makes from the same 3D model

Add a comment