Samsung Galaxy s23 ultra case set (3in1)

This is the PLA version. I roughly chopped out the buttons as you can see. Very roughly. The power connection side I had support in but with poor layer adhesion, a fault on my part/ the PLA I used, you can see more came out than should have. Overall, it is a functional print. I like the change to the sides where it only rolls over in the corners and not all the way down the sides - about 2cm from each corner. I'm waiting on a case to come from Quadlock sometime in the next month so this will do nicely in the short term. 60C bed, 210C nozzle. Sliced using Ultimaker Cura. Thank you to the designer.