Skip to content

Piggy Sitting(Sir Pigglesfree): single extrusion version

Make’s quality: 5.0/5 (1 vote)
Evaluation of members on the quality of 3D print, material, post-processing, photo, etc.
3D Model

Make’s description

Sliced with the new PrusaSlicer, using the suggested settings.

The 50% version took 1 hour 8 minutes to print.
The 100% version took 3 hours 41 minutes to print.

Good to see Loubie putting her makers mark on the model.

  • Raft: No
  • Resolution: 0.2 mm
  • Temperature: 215 ℃
  • Support: No
  • Infill: 15 %
You have a problem with this Make? Report a problem.

Other makes from the same 3D model

Add a comment


100% secure payment with PayPal or Credit Card.