Skip to content

Support for Dremel 200

Make's quality: 0.0/5 (0 votes)
Evaluation of members on the quality of 3D print, material, post-processing, photo, etc.
3D Model

Make's Description

I do a lot of sanding and polishing with my Dremel. In my case, it's usually easier to hold the work rather than the tool, so it's been a good choice.

I used Ultimaker Cura 4.5.0

The print took roughly 21 hours and 30 minutes.

  • Raft: No
  • Resolution: 0.2 mm
  • Temperature: 220 °C
  • Support: Yes
  • Infill: 38 %
  • Speed: 50 mm/s

Add a comment