Skip to content

Lara Croft with a single gun

Did you 3D print this model?

3D Model

Make's Description

I used Cura. On 60% size it was done in less than 6 hours with supports (not much optimized). I chose bad support setup and it was hard to remove. So hard I dropped the model while trying to remove supports and hand with gun ripped so I had to tear it off and do a really HOT fix with some stove hob = masked that as a bracelet.
For painting I used revell colors and it was a nice gift for my girlfriend (she really loves all of the Tomb Raider games) after all :)


  • Raft: No
  • Temperature: 200 °C
  • Support: Yes
  • Infill: 10 %

Related contents