Skip to content

Dice Tower sized for resin printers

?
Make's quality: 0.0/5 (0 votes)
Evaluation of members on the quality of 3D print, material, post-processing, photo, etc.
  • 2 likes
Maker
3D Model

Make's Description

Failprint. I printed the Open Tower in One Piece. The problem was being able to unstick the model from the base after 10 hours printing.I was using 45s/bottom exposure and 12s/normal exposure I needed to use so much force than the delicate jardin cracked. Also noticed it is not possible to fully cure this model with solar light only using opaque resin. Probably will try again with translucent resin and printing in two pieces.

Other makes from the same 3D model


Add a comment