Skip to content

Burj Khalifa

Did you 3D print this model?

Maker
3D Model

Make's Description

Really cool model, well done.

I scaled this one to 80% on the Z-axis and 85% on the X- and Y-axis to make the antenna a little thicker, and the results are pretty good.

I made this one using a 0.4mm nozzle, 0.2mm layer height, 10% infill, 50mm/sec print speed (but reduced it significantly when it reached the top) to be sure everything went fine.

I hope you like it.

Best regards,
Erwin

  • Raft: No
  • Resolution: 0.2 mm
  • Temperature: 205 °C
  • Support: No
  • Infill: 10 %
  • Speed: 50 mm/s

Related contents


Add a comment