Articulated Tarantula

Printed with a Mars 2 Pro Resin printer on 80% scaling (C Model) with ChituBox

Exposure Settings i used:
Bottom Exposure: 30s
Exposure: 2s

Temperature was at the time of the print at around 22-24 C (not 100C :P)

After i washed it i removed the bulk of the excess material let it dry with a fan and put it in the UV Station with 30s intervals and moved it around till i got 3 minutes in total.
It did take quite a while removing the excess Material off of the Print with a wire cutter and a sharp knife also good lighting and patience is key!

Also i used some PTFE Spray on the Joints to let it move around just a bit better and might let it survive a bit longer for usage.