Gyro Winder / Watch Winder / Watch winder
- 1 like
I used ball bearings with outer Diameter 6mm, inner Diameter 3mm. Inserted them by drilling up the bores of the middle ring. Therefore, I didn't need a reconstruction.
Be carefull of the printing direction, especially in the area of the screw mounts, there the printing layers tend to break during screw fastening.
Little hint: to insert the nuts, heat and insert them by use of a soldering iron...
- Resolution: 0.2 mm
- Temperature: 220 ℃
- Infill: 25 %
- Speed: 75 mm/s