Yamaha Tenor Sax YTS 280 Case Wheels

These are the files for wheels that I made for my student tenor sax case.

Assembly (when done printing):

8x M3 screws
4x each file printed
1x Super glue (gel or liquid)
4x 608zz bearings
1x lighter is useful
1x pair of pliers is useful
1x hammer is useful

1. Screw 1 M3 screw into the back of each Tenor Sax Wheel Connector (not the small part that connects to the bearing - the side that is in the first picture)

2. Press a ball bearing into each Tenor Sax Wheel (you may need a lighter to warm the wheels so that you can press the bearings in - you also may need pliers or a hammer to press them in)

3. Press the wheels onto the ball bearing connector on the Tenor Sax Wheel Connector (small part that sticks out referenced in step 1)

4. Screw 1 M3 screw into the less filleted end of each Tenor Sax Wheel Blocker (it is ok to screw it into either end but preferred to screw into the less filleted end)

5. Screw the screw on the Tenor Sax Wheel Blocker into the wheel side (side without the previous M3 screw) of the Tenor Sax Wheel Connector

6. Super glue each wheel to each foot on the case the way that is most comfortable to you.

-