The starter plug is a part that is used to block the hole left by the starter when it is removed from the engine (when the ignition is changed to an internal rotor, etc...)
Once this part is printed, it must be positioned on the housing, then the original screws that held the starter (M6) must be placed, without tightening them only so that they serve as a guide, then gently tap with a mallet or hammer and the obturator enters without difficulty, then tighten the not too strong screws because the part remains made of plastic. The piece is mounted.
hull width 1.6mm
205°c Ice filament
fichier 3d de moto et autre modélisation
Hésitez pas à me contacter sur Instagram @max_impression_3D
Page translated by automatic translation. See the original version.
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!