Lego 75252 UCS Star Destroyer Stand (25° angle)

Angled stand for UCS Star Destroyer set no.75252 designed so it fits on narrower shelfs (mine is 36cm/approx. 14in. deep). Stad is designed so that it can be printed on Prusa I3 mk3s sized printer. Tolerance on connection point are pretty tight (0.05mm) so your printer has to be dialed in pretty well, on the other hand ot does not require any glue.

To mount the set it is best to remove everything from the skeleton - bridge with superstructres below, 8 body panels - 4 top 4 bottom and the engine assembly. Then you have to disconnect two black beams connecting main "spine" with the lower one by removing (partially) two orange pins (see 4th and 5th pic.) then you have to thread the lower spine through the rear leg of the assembled stand (pictures 6-8) after that you simply mout the skeleton using same holes and axles as with the original stand (last two pictures) and put all the parts back on.

0.2mm layer, 4 perimetres 20% inffil (I used gyroid), printed in PLA