G17R Rubber Band Gun

By popular demand I have designed this rubber band gun based on the Glock 17 Gen 5. Like my other designs it prints in place, no assemble, no glue, just remove the supports and fire.

Below is a link to the rubber bands this is designed for. If you use stronger rubber bands, or load more than four shots it may result in failure of the rotor.

Alliance Rubber 96315 Advantage Rubber Bands Size #31 , 1 lb Box Contains Approx. 850 Bands (2 1/2" x 1/8", Red) https://www.amazon.com/dp/B008X09PDC/ref=cm_sw_r_cp_apa_i_Pp.KCb72JE91W

Because this is a highly detailed replica of an actual firearm, only print it bright colors to avoid it being mistaken for the real thing.

If you don't heed the warning above please print the orange tip and glue it to the muzzle.

Layer Height: 0.2

Supports: From build plate only, if you are using custom supports ensure to support the rotor and the axle is spins on. Also remove any supports that extend up into the body as they will be difficult to remove.

4 shells

Infill: 30%

Orient the model so that the barrel is pointed upward and tilted at a 15 degree angle towards the top of the gun as seen in the picture.