FrameCorp Hulk

FrameCorp is a set of simple frames that work by pressure. A system that is very easy to 3d print and allows you to customize the inside content of the frame.

The frames can be hung on the wall or placed on a table using the included brackets. Available at the moment in 3 sizes allowing 120x120mm, 200x120mm and 200x200mm designs to be placed internally.

This time I present the Hulk plate with a design inspired by the huge green-skinned character created by Stan Lee and Jack Kirby. Bestial, hulking, muscular is "the mass" alter ego of Bruce Banner. "Hulk smash!" ;)

The base plate features a thickness of 1.8mm and color jumps every 0.8mm.

The Hulk board contains the following elements:

FrameCorp_Hulk_120x120

FrameCorp_Hulk_200x120

FrameCorp_Hulk_200x200

The rest of the elements (Frames, fixtures and other extras) can be downloaded for free at the base project link:

FrameCorp Base link:

https://cults3d.com/en/3d-model/various/framecorp-sistema

Follow this project and others at:

https://www.instagram.com/krcorp/

Other related plates:** **

https://cults3d.com/en/3d-model/various/framecorp-hydra

https://cults3d.com/en/3d-model/various/framecorp-shield

https://cults3d.com/en/3d-model/various/framecorp-captain-america

https://cults3d.com/en/3d-model/various/framecorp-ironman

#framecorp #frame #frames #frames #frames #frames #decorative #design #creative #creative #home #gift #game #video game #video game #friki #customizedgifts #impresion3d #cults3d #maker #stl #pla

#hulk #brucebanner #shehulk #shield #hydra #marvel #movies #comics #videogames #avengers #mcu

3D PRINTING PARAMETERS

FRAMES:

Supports: No

Resolution: 0.2mm

Filling: 10%

Filament material: PLA / PETG

Horizontal Expansion: To adjust the correct fit between frames you may need to adjust the horizontal expansion in steps of +-0.01mm. I recommend that the plates fit somewhat tightly into the frame.

PLATES

Supports: No

Resolution: 0.1mm or 0.2mm

Filling: 100% or better I advise setting the lower print layers to 30 layers.

Filament material: PLA / PETG

Color jumping sizes:

Base:1.8mm

Color level jump: Normally every 0.8mm or 1.6mm depending on the design.