This was originally designed to be a copy of a Vandoren B45 but the CAD work and precise measurements proved to be too complicated to do it justice
Instead, this is a just barely functional clarinet mouthpiece.
Print with no larger than .25mm layers, and some support is required.
Once printed, you will need to sand the facing and rails so they are absolutely even and smooth. You will almost certainly need to adjust the reed tip spacing and perhaps the tip curvature to make it playable.
This is not recommended for somebody who has never played before, as carefully adjusting the reed tip curvature and spacing is very hard to do well. (Even I'm pretty bad at it) On the bright side, if you mess it up too badly you can always start over for cheap ;)
No cork groove is included, but a piece of tape on the joint section works quite well.
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!