Citadel paint stand

This is a remix of andersklahr Citadel Paint stand https://www.thingiverse.com/thing:3773813

I liked his design but felt I could make it more robust by using 10mm threaded rod or all-thread from the hardware store

I had a few of the old citadel hexagonal paint pots as well as the new ones, whilst printing andersklahr original hexagonal design I discovered if I scaled it up it would also fit the round citadel paint pots.

so simplified to a single base print, a mid section - print as many as you need and stack them up and finally a modified top section suitable for paint brush and tool storage.

finally you will see some spacers you can print if you need to these are required if you have the taller paint pots.

Base paint stand requires:
2X 10mm hex nuts
10mm threaded rod
support for the nut recess underneath
3 shells / walls
4 layers top and bottom
10% infill

universal paint pot:
2 shells/ walls
4 layers top and bottom
no infill
no support

Paint stand top with brush holder:
2 shells/ walls
4 layers top and bottom
no infill
no support

-