Articulated Jumping Spider _ Print-In-Place Jumping Spider

This Articulated Jumping Spider is printed with no support material and is flexible directly off of the printer after the brim removal. Ensure the bed is level and you have proper bed adhesion. A Brim is Absolutely Necessary. If printing on the Bambu Lab you must slow down the Travel Speed I used 300mm/s and it didn't add much extra time to the print. I also set the Normal Printing Acceleration to 5000mm/s. The models shown in the photos were all printed on the Bambu Lab X1 Carbon with the AMS system using three colors to print these models. I used all PLA materials. The Adbomen (Back end) of the spider prints as an Articulated feature but you can bend up and lock into place on the body and push back to sit your little spider upright.

There are 2 files included in this purchase...

• Articulated Jumping Spider STL File
• Articulated Jumping Spider_Mini 50% STL File

All MZM Digital Designs are protected under Copyright Law. This purchase gives you the right to download the stl file and 3D print this design for your PERSONAL use. You do not have permission to resell or redistribute these digital files in any way. This includes altered or "remixed" versions of the designs. Prints of the design cannot be sold without authorization.

To legally sell 3D Prints of this design, you can obtain authorization by joining my Patreon page:
http://patreon.com/MZMDigitalDesign

Copyright © 2023 ----MZMDigitalDesignLLC----All Rights Reserved

Printed on the Bambu Lab X1 Carbon using the AMS System.

Material: PLA

Resolution: 0.12mm Fine

Supports: No

Brim: YOU MUST USE A BRIM ( I used a 10mm Brim)

Infill: 15%

Infill Pattern: Grid

Ensure the bed is level and you have proper bed adhesion.

If printing on the Bambu Lab you must slow down the Travel Speed I used 300mm/s and it didn't add much extra time to the print. I also set the Normal Printing Acceleration to 5000mm/s