Build Plate Garage for AMS STAND. Expansion Pack 1

AMS STAND EXPANSION PACK 1
Then there is an expansion package ready for AMS STAND. Smart solution for where you can store your building plate without them being in the way but close at hand.

Guidance.
To use the expansion pack, if you have already printed the stand, replace the front and back at the bottom of the stand with those from the expansion pack, then add the 2 rails from the expansion pack

To use the expansion pack, if you haven't printed the stand yet, select the rack size you need, then remove a front and back, then add the front and back and the 2 rails from the expansion pack

Follow the link to Expansion Pack 2
https://cults3d.com/en/3d-model/tool/ams-stand-drawer-system

ATTENTION!!
This is not the AMS STAND itself. This is an expansion pack. Follow the link to the AMS STAND
https://cults3d.com/en/3d-model/various/ams-stand-infinite-composition-possibilities

All files contain the settings that I recommend, be aware that support is set up to be PETG while the print itself is PLA, if you do not have the option, you must remember to change the support settings.

I recommend adding reinforced areas at all joints, watch my how-to video, access video here! https://www.youtube.com/watch?
v=u3M6P5c4IiI

I also recommend adding PETG as support, this gives a very precise hole for the joints. watch my video how to do this. access video here! https://www.youtube.com/watch?v=Lf1iQYXnVdU