Wet-Dry Polishing Shroud for Harbor Freight Drill Master 7in Polisher

This polishing shroud is designed for either wet or dry polishing and keeps the water / dust contained. The shroud is designed to fit the Harbor Freight Drill Master 7in Polisher (62861 - https://www.harborfreight.com/7-in-10-amp-variable-speed-polisher-62861.html )

The original purpose of this shroud was for use on making concrete countertops. To finish counter tops it requires both wet and dry polishing. I am doing a full how-to write-up on DIY concrete countertops... https://wiki.malamaker.org/projects/concrete-counter-tops

For Wet Polishing you will need a USB water pump and 7.9mm (5/16") vinyl tubing.

For Dry Polishing you will need a 1.25" hose end. Make sure you have the proper filtering in your vacuum or you will destroy your motor with the fine dust.

Hardware:
(2x) M5 x 6.7mm Tapered Heat-Set Inserts for Plastic ( https://www.mcmaster.com/94180A361/ )
(2x) M5 x 12mm Button Head Cap Screw
(2x) M5 Washer
(10x) M3 x 12mm Stainless Steel Button Head Cap Screw
(10x) M3 x 3.8mm Tapered Heat-Set Inserts for Plastic ( https://www.mcmaster.com/94180A331/ )
(1x) M8 x 12mm Button Head Cap Screw

USB Pump: https://smile.amazon.com/Driew-3-5-9V-Submersible-Brushless-Waterproof/dp/B01CG2YE6K

5/16" Vinyl Tubing: https://smile.amazon.com/Sealproof-Unreinforced-Tubing-16-Inch-American/dp/B07G9YY7GT

It is recommended to use Carbon-fiber filament (PETG or ABS). TPU / Ninjaflex / Ninjaflex Cheetah is to be used for the shroud skirt.