Skip to content

Tuning fence

Creation's quality: 5.0/5 (1 vote)
Evaluation of members on the printability, utility, level of detail, etc.

3D model description

I design this to test the best settings for new filaments with minimal material to save time and cost.
You can run this as a torture test too. (so the name fence of death)
Start from higher temperature then try lower the temperature every 5-10 degrees to see the results. You can adjust other settings for retraction, speed, etc. But I recommend playing with temperature first.
I found out the best temp. for my new PLA filament was in fact 175 degree to give the finest detail.
Print with a small brim for stability.

3D printer file information





Issue with this design? Report a problem

Best sellers of the category Tools

Add a comment

Would you like to support Cults?

You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:

  • ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.

  • AFFILIATION: Make your purchases online by clicking on our affiliate links here Amazon or Aliexpress.

  • DONATE: If you want, you can make a donation via PayPal here.

  • WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!