Tronxy X3 Supercooler - hot end fan shrouds
- 2.2k views
- 5 likes
- 57 downloads
3D model description
UPDATE: Check out this Mitten Cooler newer design I just released. Should work well and need only a 5015 fan.
My stock built Tronxy X3 printer's hot end could not go above 205ºC. The stock design cools the heater block too much. I wanted to printer higher temp >220ºC filaments and could not with the stock printer. So here is my solution.
It reuses the screws from the hot end radiator, but they only work if you remove the washers.
It's designed for left and right 30x30x10mm fans (12v) but you could get by with just one. If you add the left one, then you need to use my custom x stop.
Custom x Endstop: http://www.thingiverse.com/thing:1906501
Wire the 30mm fans in parallel -- and added my own y-connector.
If this is helpful, a tip would be nice. At least a like and show your makes.
Assembly video: https://www.youtube.com/watch?v=aMM67JGe3qQ
Please note, this is not compatible with the auto leveling sensor. If I get enough requests, I may figure something out. ;)
3D printer file information
3D design format: STL Folder details Close
2019-04-15 at 14:56
?Published to Thingiverse on: 2016-11-21 at 04:34
Best sellers of the category Tools
Would you like to support Cults?
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!