CHECK OUT MY NEW AND IMPROVED DESIGN, THAT IS EASIER TO ADJUST IN WIDTH USING A SCREW
This is a filament spool mount holder. It works with 4 bearings. Inner bearings diameter should be 8 mm. The knob is made 8.05 mm, so its a press fitting. I had to sand it down a little myself for a good fit.
It has a custom width, so it should fit most spools.
It is quite sturdy, and has a good slide, with the right amount of friction. I recommend fixing an elastic to push the two holders together.
UPDATE: I've made a loop around for fixing the elastic, since the stick is not very good (Too tiny). I have not yet printed this, so ill leave both files up.
UPDATE2: I've added a new rail with Ø10mm holes for fixing neodymium magnets into. I've used 2 screws into the box where my 3D-print is. This allows for a much better fixture and easy removal when changing filament or when the spool gets in the way.
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!