Because I needed propeller shields adapted to my model and the original carbon feet were too easily detached from the ground (and in flight ...), I decided to draw directly a model that proposes The two functions.
The distance to the motor is 12mm. Holes Ø3mm.
Designed for 5 "or less propellers (5045, 5030 ...)
Mounted on a 250mm drone
The foot is only 15mm only (but leaves a good centimeter under the model) to keep Of lightness (only 20Gr for the 4 pieces)
Little interest to increase the print quality (or filling) too much, the interest is to be able to quickly replace the parts during a crash.
Cost price 0.87 € for the 4 protections
Printed with PLA The carbon is a very important factor in the low cost of these printed parts compared with the almost systematic change of the propellers after a severe shock. Will surely do better!
A future version with solidification of the feet is in reflection;)
Printer: Hephestos 2
Brackets: Not necessary.
Resolution: No matter.
Print time, from 1h to 3-4h depending on settings.
Materials: ABS PLA Carbon Though
Filling: Does not matter to adapt as you want.
Page translated by automatic translation. See the original version.
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.