Skip to content

Kossel Linear Plus SKR 1.3 and various upgrades

?
Creation's quality: 0.0/5 (0 votes)
Evaluation of members on the printability, utility, level of detail, etc.
  • 528 views
  • 10 downloads

3D model description

I've been asked on a few occasions for files and references to the ongoing upgrades I've been doing to my Kossel Linear Plus and figured the easiest way to let people share my woes and successes is to create a kind of an ongoing blog. So here is the first installment of the story so far.

Parts to print.

Top Belt tensioners https://www.thingiverse.com/thing:2827665
Frame braces http://www.thingiverse.com/thing:2620272
Raspberry Pi case for 2020 frame fixing http://www.thingiverse.com/thing:1881672
Z probe holder https://www.thingiverse.com/thing:3625665
SKR Case

Thingiverse:https://www.thingiverse.com/thing:4310402
SKR Nat's Lid File attached to this project
SKR Nats fan duct File attached to this project
Nat's PSU rear mounting https://www.thingiverse.com/thing:4356933
Nat's Cable guide https://www.thingiverse.com/thing:4372918
Effector strain relief https://www.thingiverse.com/thing:2746497
Nat's Fan MOSFET mount
Top spool holder
Kossel feet http://www.thingiverse.com/thing:2848015

Parts to buy

5020 axial fan
SKR 1.3
Bigtreetech TMC 2208 UART ready V3.0 (x3)
A4988 stepper driver for extruder
Small MOSFET
Raspberry Pi
150mm USB A to B cable
Selection of metric cap head screws, nuts and T-Nuts
Panel Voltmeter
12 Volt, 2 Amp to USB micro buck converter for Raspberry Pi

Firmware

Marlin 2.0.5.3 is configured for the following:

TMC 2208 drivers in UART mode on all 3 motion axes
A4988 driver on extruder
Part cooling fan controlled from "FAN" port on board
Hotend cooling fan connect to "E1" connector on board
Stepper controller fan connect to "X-MIN" socket on sig and ground pin to fan MOSFET. 12 volt supply to fan MOSFET from 12V AUX port on board.

  • 3D file format: STL and ZIP
  • Publication date: 2020/05/20 at 10:12

Tags

Creator

License

CC BY NC


Best sellers of the category Tool


Add a comment


Would you like to support Cults?

You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:

  • ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.

  • AFFILIATION: Make your purchases online by clicking on our affiliate links here Amazon, Gearbest or Aliexpress.

  • DONATE: If you want, you can make a donation via PayPal here.

  • WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!