FAN DUCT FOR FLSUN V400

The application of these air ducts does not require the disassembly of any printhead component.
These ducts are very easy to print (use slow speeds!).
The air duct allows ventilation at an angle of about 70°.

PERFECT MATCH TO THE ORIGINAL AIR DUCTS!
Note: If the duct does not fit perfectly, you can change the scale of the model by a few tenths of a millimeter in the x or y direction.

Pieces to print:
n. 1 pc: Fan Duct Adapter FLUN V400_REV 3.stl

VISIT MY COLLECTION TO RENEW YOUR V400!
https://cults3d.com/en/design-collections/StevePro/flsun-v400

PRINT SETTINGS:
Material: PETG
Extruder temperature: 240°C
Bed temperature: 75°C
Layer height: 0.12mm
Initial layer height: 0.2mm
Line width: 0.38mm
Initial layer line width: 90%
Flow: 95%
Number of perimeter lines: 5
Density of filling: 100% (concentric)
Print speed: 25mm/s
Printing acceleration: 4000 mm/s
Enable acceleration control: yes
Print jerk: 10mm/s
Retraction: 0.6mm
Fan speed: 50%

The print settings can vary as desired by the user.