Working Dildo Reciprocating Saw - Blade Cover

Impress your workmates with this fully functioning Dildo that can be slotted to fit onto the blade of a reciprocating saw to act as a very effective saw blade protector.

It is an ideal gift for laughs and slap stick humour on the work site.

The twist to the story is that if it is printed in solid ABS - it can be used as an actual dildo for sexy fun and games. Let your imagination tell you what else you can do with it :)

We designed this for fun and we printed it in the health and safety colour for extra giggles. We hope you order it and raise more than a few laughs - designed for the "Builder" with a sense of humour!

ABS Plastic Printed 100 percent infill = 76 meters
Print time 6 hrs 26 minutes @ 0.3 layer
Position 288 degrees X
196mm length - base 57mm width - average width 37

How to finish the item...

Place into hot water and allow the item to warm up fully.

Place a support item (we use a short metal tube standing on it's end) in the water. Dry the toy then place it on top of the support with the water just up to its base. Then, while everything is still warm, drizzle acetone over enough to cover it. Wait 40 seconds and do it again. Allow to rest. As this is a solid ABS print the end result will be a gloss finish. This technique wont work for PLA. ABS is best.