"Eff You" Surprise Egg

A fun snarky 2 piece egg with a middle finger surprise inside. I thought it was a funny gag to my wife and she loved it. So she showed some friends and they all wanted some to give to their friends and family. Next thing you know, I was selling these like crazy on local social media marketplaces.

I am still selling them, but I don't have the time to meet the demand this year, so I figured I'd offer the file for someone else to make some $$ to pay off their printers.

****There is a twist to lock/close version "_twist_NOT PRINT READY" that is still in development. The design works but I believe the top and bottom have to be printed separately for it to work well.

15% Infill using ZigZag.
.16 layer height

Actual model size is a bit larger than what I print, 65% scale should give you that 3.125" size if it isn't already scaled down. The full set downloads should be scaled down.

Supports: The egg typically doesn't need supports at all, as it should print fine by itself. I usually add support blockers to the base and top leaving only the split and hand to be supported (if you print the top hovering over the base).

This .stl is 2 pieces, a top and bottom. I always use color changing silk filament so I print them together, stacked with a slight support between the 2 pieces. They are about 3.125" in size and only require very few supports. A few for the fingers and some small supports for the top of the egg sitting just off the shelf of the base.

Print time is about 4 hours depending on your printer. I use Ender 3 Pros.