Skip to content

mini stand tree jewelry tree

3D model description

I present you a mini jewelry tree that can contain 3 small pairs of earrings

it is 12.4 cm long and 12 cm wide and 1.5 mm deep, the printing time varies between 55 min shaft + support

the support fits into the trunk of the tree so that it can stand upright

as a gift the cat earrings:)

3D printing settings

50% sufficient filling rate if subsequently painted

50% printing speed not too fast for better rendering

215 ° PLA printing temperature

60° tray temperature

0.1 layer thickness

0.8 hull thickness

0.8 thickness above/below


  • 3D model format: STL



Followers Following 197
Downloaded 1696
Sales $81

je modélise depuis janvier 2017, c'est devenu ma passion...

chaque objet est modélisé, imprimé et s'il y a un défaut il est corrigé avant d'être partagé...
bonne impression... : .la créativité c'est l'art d'accomplir ces rëves
et quelques une de mes créations imprimés, ponçé, peinte et vernis sont sur :

I model since January 2017, it became my passion ...

each object is modeled, printed and if there is a defect it is corrected before being shared ...
good impression ...: creativity is the art of accomplishing these dreams
and some of my creations printed, sanded, painted and varnished are on:



Page translated by automatic translation. Suggest a better translation

Similar 3D files

Add a comment