Skip to content

Earring Display Rack

3D model description

This is a modular earring display rack. It assembles from 4 printed parts with no additional pieces necessary. The 5 center holes (at least) on the crossbar need to be carefully cleaned with a 2mm bit to fit the posts on the vertical support. The slots on the foot cross bars and their corresponding slots on the vertical support might need a little filing/sanding to remove any 'elephant foot' your printer might leave. The center of the cross bar should be carefully located and the corresponding posts on the vertical support started by hand and then carefully tapped into place. Also shown in the pictures is a portion of my design collection which is forthcoming.

3D printing settings

PLA 190 degrees .2 layer 40 mm/s 30% infill grid, no support, skirt 2 passes 2mm away. the STL's are provided separately and also as a suite that can be printed in one pass on a 240x240 printer bed if carefully placed

  • 3D model format: STL



Followers Followings 0
Downloads 35
Sales $5




Similar 3D files

Best sellers of the category Jewelry

Add a comment