Wall shelf “Oyster fungus”

An organic shelf that “grows” from your wall.
If you need a small shelf for anything you want to make visible every day (like your favorite Benchy or a small plant) this is the one for you.

Versions
- Oysterfungus_shelf_default: The default size
- Oysterfungus _holder_default: the holder for the default size with a screw-hole diameter of 5.5mm
- Oysterfungus _shelf_small: A mini version (60% scale)
- Oysterfungus _holder_small: A holder for the mini version – simply scaling down the default version would make the holder unusable
- Oysterfungus _shelf_no_holder: The Shelf without the cut-out intended for scaling down below the mini version – must be mounted with glue or tape
- Oysterfungus _holder_for_upscaling: If you want a huge version, scale up the default shelf and use this holder – the only difference is the screw-hole size of 3mm that will be usable when scaled.
- Oysterfungus_shelf_magnet_internal: A version for making a fridge magnet with mid-printing insertion (40% scale)
- Oysterfungus_shelf_magnet_external: A version for making a fridge magnet (40% scale)

Instructions
1. Print the shelf and holder
2. You can either screw or glue it onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation.
3. Insert the shelf by moving it horizontally onto the holder until the holder is completely inside the cutout. Then proceed to move the shelf down and the holder locks in.
4. Enjoy!

Want more Mushroom designs? Find my collection here
Wall shelf Pinicula Fungus
Wall shelf Djamor Fungus
Wall shelf Tinder Fungus
Wall shelf Amanita Fungus
Wall shelf Ostrea Fungus
Vase Abietinum Fungus
Bowl Hirsutum Fungus
Plant Label Silvaticus Fungus

Want to support me?
Become a member for exclusive designs, early access and discord benefits

Instructions fridge magnet
Magnet required: a 20 x 2 mm neodymium magnet

Internal magnet
- The internal magnet shelf file has a cutout inside to place a magnet during the printing process. All mushroom wall shelf designs have the cutout at the same height – so you can print all of them at the same time.
- Use a copper nozzle for printing (nonmagnetic)
- Slice the file and check the layer height of the last layer before the bridging over the hollow cutout starts. With a 0.4mm nozzle it should be at layer 15. Implement a pause after that layer with your slicer.
- Start the print
- At the pause insert the magnet and continue printing. As always be careful with magnets and electronic parts!

External magnet
- Print the file
- Glue in the magnet after the printing process – the cut-out is sized to let the magnet stand out just a bit

Size default assembled: 100 mm x 155 mm x 160 mm
Don’t forget to post your makes!

Required build volume: 160mm x160mm x 120 mm
Material usage: 130g
Print time: 11h

Material: PLA
Print direction: stls are rotated correctly, check images
Support: none
Nozzle size: 0,4 mm
Line width: 0,4 mm
Layer height 0,2 mm
Outer walls: 3
Infill: 15%
Build plate adhesion type: none
If you experience any problems, please feel free to contact me on twitter or Instagram