Tentanana & Tentacone

Perfectly Print-in-place
No Support Needed

A tentacle, a cone, and a banana. It's hilarious and absurd, and I love it!

No glue is involved, and you only have to screw the tentacle in.

Go print this masterpiece of weirdness!

Super easy to print! Great gift 🤍

IMPORTANT NOTE:

If you want to sell 3D prints based on my designs legally, please become a Patreon on my page:
www.patreon.com/holoprops

All of my Designs are covered by a Creative Commons Non-Commercial License. You can only print this model for your Personal Use. The sale of prints using my designs is the sole right of myself, the designer, and my active Patreons to do so. Please understand every design is days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:

• No support is needed. Everything is ready for printing.
• Layer Height 0.2mm
• Nozzle 0.4mm
• Recommended infill 15%.
• Recommended Infill Pattern: Gyroid.

• Prepare and clean your bed for excellent adhesion.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam and place it behind where nobody will pay attention.
• Make sure your printing and bed temperatures are adequate for the filament you are about to use.