Spice Rack

A very simple and cool looking Spice Rack.

It uses 0.5 inch or 12.7mm high pieces of wood or anything that is that thickness. You can even use Dowels

It is very sturdy, it uses around 115g of filament per side and prints in 18 hours at the settings I used. Included is a PDF File with all the print settings I used.

You can make the pieces of wood as long as you like it fits perfectly in most standard upper cabinets and fits most standard spice bottles.

Check out the Stack master Pro all in one storage solution if you have not already seen it. : https://cults3d.com/en/3d-model/tool/stack-master-pro

0.32mm layer height (or pretty much anything)
0.4mm Line Width
Wall count : 2
Top / bottom layers : 4
Infill : 15%
Infill pattern : Cubic
Printing Temp : 200°C
Bed Temp : 60°C
Type of material : PLA
Brand : Econofil
Print Speed : 50mm/s
Print with supports : No
Adhesion type: Skirt