Sitting Cat Decor

Print-in-place
No Support Needed
💙💙
What an adorable cat for your desk setup!

The legs form a perfect 90° angle so you can put the cat in a keyboard corner or a mousepad corner.

Super easy to print and assemble! Great gift 🤍
Guarantee 100% cute & Kawaii! (✿◠‿◠)

Use a little point of super glue to assemble the elements of the face. (What I am using: BSI Insta-Cure+)
⭐⭐
Please, tag me on Instagram or TikTok (@holoprops); I would be thrilled to see your prints!

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the platform of your liking:
🔵Thangs - www.thangs.com/designer/Holoprops (http://www.thangs.com/designer/Holoprops)
🟠Patreon - www.patreon.com/holoprops

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:

• No support is needed for any parts. Everything is ready for printing.
• Layer Height 0.2mm
• Nozzle 0.4mm
• Recommended infill 15%.
• Recommended Infill Pattern: Gyroid or Cubic
• Avoid any Elephant Foot.

• Prepare and clean your bed for excellent adhesion.
• Do not print over 50 mm/s. A lower speed, like 40 or even 30 mm/s will always produce better results.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam and place it where nobody will pay attention.
• Make sure your printing temperatures and bed temperatures are adequate for the filament you are about to use.