It's a two part flower pot with a lifted bottom acting as a water holder. Pot for the plant has a 4 holes so the rope will have contact with the water witch goes up the rope and to the roots. Outer shell is elongated on the one side so there is a place to add water to the reservoir without lifting the plant pot.
Print is separated in two parts, inner and outer shell. Both of them need supports at the bottom but only for couple of layers i could make the version with 45˙ so there is no supports but I liked the aesthetic of this lower angle one better. In my case reservoir holds the water well of the printer, no need for additional water insulation, I had the flow rate at 98% as a normally do for all prints.
Architecture student specialized in digital fabrication, design and 3D printing.
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!