Rocket Taking Off Pencil Holder Space Shuttle Launch Desk Decoration

***IMPORTANT NOTE: The preview of the 3D model contains a GLITCH. I'm not sure what's causing it and I am in the process of fixing the issue, but for now please see the last photo that shows the actual model. Despite the preview appearance, the model is solid and prints well. If you download it and experience problems, please contact me and I can send you the original file via email.

I'm studying at a university near the Space Coast, and the frequent launches inspired me to make this replica of a rocket taking off! It makes a great desk decoration, and it has room inside to hold a few pens and pencils. I hope you enjoy this model, and please share photos if you print it! Please don't hesitate to contact me if you have any questions about the model.

For all files:
Layer height: 0.18 mm
Print speed: 60 mm/s
Travel speed: 80 mm/s

For "rocket_holder_smoke":
Infill: 20%
Supports: None
Print time: 7 hr 5 min

For "rocket_holder_cap":
Infill: 17%
Supports: Minimal supports necessary on the outside (I used auto-generated supports); none needed on the inside.
Print time: 1 hr 4 min

For "rocket_holder_smoke":
Infill: 14%
Supports: I used auto-generated supports and removed the supports from the inner cylinders and the small details near the top.
Print time: 14 hr