Rocket Lift off Decor

Print-in-place
No Support Needed

This model is super cool and fun to print. IIt has a sleek design and a rocket-shaped stand that holds your Switch securely.

The best part is, everything is print-in-place, and no support is needed.

You only have to screw the thrusters in the rocket and then the rocket to the fuel.

Just load the file, hit print, and enjoy your Rocket Decor!

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the platform of your liking:
🔵Thangs - www.thangs.com/designer/Holoprops
🟠Patreon - www.patreon.com/holoprops

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:
• No support is needed to print this dock. Everything is Print-in-Place.
• Layer Height 0.2mm
• Nozzle 0.4mm
• Recommended infill 15%.
• Recommended Infill Pattern: Gyroid or Cubic

• Prepare and clean your bed for excellent adhesion.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam and place it where nobody will pay attention.
• Make sure your printing and bed temperatures are adequate for the filament you are about to use.