Nature Grass and Shrooms LED lamp

NOTE: PA1© - FOR FULL ACCESS TO ALL MY MODELS, + EXCLUSIVE STLs AND A COMMERCIAL LICENSE FOR SELLING YOUR PRINTS, YOU CAN JOIN MY PATREON HERE:

https://www.patreon.com/PA1_MAKER

Mushrooms and tall grass! Almost like in a fairy world!!!!
Cute little lamp, very easy to print with standards settings.

All the components are already hollow, so you dont need special settings like vase mode or so..

Only 2 walls, and everything should print fine without supports, except for the big mushroom base.

If you are experiencing troubles with the mushroom tops, you can add supports (touching platform only!!). But they should print fine without supports.

For the lighting, i used an LED lamp from the dollar store. But i will try to add some optic fibers from an old christmas tree to guide the light to the top of the grass.

Maybe you will have a better lighting source. ;)

The base can accomodate a wide variety of lamps.

INSTRUCTIONS:

There's a footprint/hole on the base for each component.

Just print everything and glue them together STARTING WITH GRASS. (the tip of the grass should poke towards the exterior)

Then put the two mushrooms together and THEN put them on the plate. DO NOT glue the foot of the mushroom before glueing the top!! It will be much easier to glue the whole thing in the right position this way.

Im sorry, i dont have any exploded views this time, 'cause i've lost them... :( But it pretty straight forward to do. ;)

Happy printing!! :p

NO COMMERCIAL USE ALLOWED

0.2 layer height. Well calibrated printer. That's it. No need for mode vase, everything is already hollow. Put 2 walls in your slicer and that's it.