Lamp Shade 095

This is a table lamp shade to give soft light in the corner of your room.

It is designed to fit on a 4 inch/10cm led display base. The printed shade sits on top of the base, it is not attached. I used an led base from Amazon here: https://www.amazon.com/dp/B08Y5GCPTC?ref=ppx_yo2ov_dt_b_product_details&th=1

Other bases might work as long as they are 4 inch/10cm around.

The lamp shade should be printed without a top or a bottom. The stl file is solid with a top and bottom so be sure and put 0 bottom layers and 0 top layers in your slicer.

The vase in the photos is printed in vase mode and has not been scaled and is printed at 100% of the stl file. The x and y axis shows 121mm wide and z is 160mm tall. It can be printed in any color of pla. A lighter color will let light shine through better and show off the design better. The photos show the vase printed in mint by 3d Solutech. The lamp shade can be printed in spiral vase mode or can be printed in normal mode by unchecking vase mode, set walls to 1 and 0 top layers, 0 bottom layers and 0% infill. A brim is recommended, as a single wall on the lamp will have difficulty sticking to the print bed.

Nozzle: .4
Layer height: .2
Walls: 1 perimeter
Wall line width: .8 recommended, .4 or .6 optional
Bottom layers: 0
Brim: yes 4mm or more
Supports: No