Based on my twisted gear vase, this is an ornament for your hanging pleasure. A 30mm round LED tealight fits snugly in the base (after you cut off the bottom) or you can just glue a hook on or whatever and hang unlit.
Print with zero infill and no bottom layers if you can get it to stick. I print with bottom layers on and just cut them off.
Make sure cooling is on or you won't end up with a pointy end. I sure didn't . Worked out though, they just have kind of a rough rounded tip.
If you print in nylon, dye them whatever color you want.
Insert a 30mm (approx) round LED tealight in base. With the 618 material, it's pliable enough to have the lights fit tightly but not hurt the print with the stress. I just push in far enough to leave the half of the light that you twist to turn it on. With ABS you might want to scale up a percent or two and glue the light in place.
Then drill a hole to attach a hook, or glue one on, or whatever you figure out works best for you.
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!