CUTE FAIRY HOUSE V4 - THE APPLE!

NOTE: COPYRIGHT PA1© - PERSONNAL USE ONLY. SUBSCRIBE TO MY PATREON TO GET ALL MY FILES FOR FREE, PLUS EXCLUSIVE MODELS AND A COMMERCIAL LICENSE TO SELL YOUR PRINTS. LINK TO PATREON :

https://www.patreon.com/PA1_MAKER

Here's the fourth addition to the fairy house collection! Great for your landscaping, large flower pots, or even in your vegetable garden!

This model is super easy to print and requires NO supports.

The model is multipart, so NO need for a multicolor printer. Any printer can do it!

All parts are printable without supports.

The assembly is really easy, using small amount of glue.

The model can be scale to any size, but the original size is the smallest one i have tested without loosing details. So its possible to scale it up with no proble, but scaling it down may cause some issues.

FOR THE LEAVES: They are flat when printed. Use a little bit of heat (i.e. heatgun) to slightly bend them at the angle you want. You need to print 3 of them. When joined together, the base of the leaves will form a circle. Make a few dry fit tests (without glue) to see if they are bent correcly and where you want each leaves. What i did on my side is to put all 3 leaves in place after bending them, arrange the orientation by rotating them in the carrot body, and then drop a bit of glue in the center to hold them in place.

Detailed instructions are also included in the form of an exploded view.

You can find the other fairy houses here:

https://cults3d.com/en/users/PA1_MAKER/creations

As usual, if you have any problem or suggestions, feel free to send me a private message!

Have fun my friends! Keep printing!!!