Cute Candy Corn

This is THE print for the Halloween Spirit!
Guaranteed 100% Super Cute & Kawaii!

Easy to print - No support needed - all colors separated nicely

Use a little point of super glue to assemble the elements. (What I am using: BSI Insta-Cure+)

Please, tag me on Instagram or TikTok (@Holoprops); I would be thrilled to see your prints!

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the platform of your liking:
🔵Thangs - www.thangs.com/designer/Holoprops (http://www.thangs.com/designer/Holoprops)
🟠Patreon - www.patreon.com/holoprops

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:
• Layer Height 0.2mm
• No support is needed for any parts.
• Nozzle 0.4mm
• Recommended infill 20%.
• Infill Pattern: Gyroid

• If you have issues printing the eyes and the mouth, use a raft.
• Do not print over 50 mm/s. A lower speed like 40 or even 30 mm/s will always produce better results.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam behind the cup and place it where nobody will pay attention.
• Make sure your printing temperature and bed temperature is adequate for the filament you are about to use.
• If you follow the recommended settings above, you do not need any support to print this item.