BIRDHOUSE - THE OLD BARREL

NOTE: COPYRIGHT PA1© - PERSONNAL USE ONLY. SUBSCRIBE TO MY PATREON TO GET ALL MY FILES FOR FREE, PLUS EXCLUSIVE MODELS AND A COMMERCIAL LICENSE TO SELL YOUR PRINTS. LINK TO PATREON :

https://www.patreon.com/PA1_MAKER

Super cute tiny barrel for your feathered friends!

Only a few parts, easy to assemble and so adorable!

-No support
-Fits almost any printer! Can be printed with a prusa mini with no
problem. (biggest part 154x154x175mm)
-All parts already placed in the right orientation
-Detailed instructions with exploded views.
-Cleaning door under the birdhouse for seasonnal cleaning.

You will need the following hardware:

-(5x) m3x6mm screws

-(4x) m4x10mm screws

I suggest to use a brim for the braces and the main body of the barrel. First layer is only a few circles, so its better to secure everything with a brim.

Exploded views and instructions are included, but everything is super simple to assemble. Just be sure to put all the braces at the right place. Two braces are slotted at the back to let you open/slide them in place. Braces positions are indicated in the instructions.

Note: On the cleaning door, you have three sets of holes: The outer ones are for screwing the door on the body (5 in total). The one in the middle, arranged in a square pattern are for the support. And finally, the three other small holes between are for drainage only. Nothing to screw in those last holes.

Final note: Don't use a super dark brown. Try to have a moderate or light brown, to prevent any overheating inside the birdhouse. And remember: Birdhouses shall be installed in a shady area, with the entrance facing the opposite direction of prevailing winds. In most country, it means the entrance should face a north/east direction.

If you have any questions regarding the design or the assembly, send me a message! I will try to help you as much as i can. 🙂

Have fun and happy printing!!!