3D name from letters - comic font

Create your own name in 3D!

The file contains the complete alphabet in a comic like font. Print the letters you need and snap them together.
Don't forget to print the endcaps to complete your nametag.

You can even use the letters to print your own message or slogan.

No support needed!

To snap the letters together. Simply put them on a table and push them into each other sideways. You can always pull them apart again by pulling firmly.
Due to the print orientation the snap fits are flexible and strong.

The 3D letters were tested in PLA with 0.2mm layer height. Print in the given orientation and no support is needed. Ensure a good first layer adhesion with sufficient bed temperature and slow first layer speed. Avoid elephant footing.