Well so the WPL 1/16 C14 is considered a rock crawler, considering the low speed and grippy tires of the kit. But the CG is too high.
The reason i made this is to make a lookalike fuel tank that houses 2x 18650 Li-ion inside, and where it mounted, is at the center of the chassis and much lower CG than the stock location, reducing tip over at steep climb angle
a. Side fuel tank V2 - print at 0.3mm, upright for best finishing, with brim and support
b. Clamp 1 & 2 - print at 0.1mm, brim is a must
c. Cover + & - V3 - try print at 0.1mm, with the symbol facing up
Drill the fuel tank mounting point with 2.5mm drill bit, then screw it onto chassis with M3 screw, glue the Clamp onto the tube. Once you have wired up the 2 Li-Ion, cover it up with the Cover + & - file
Get genuine Panasonic NCR18650B here
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!