Just done up the final paintwork and test 3d printing of all part of Wheeljack, so he's all ready to roll out!
Top and bottom parts have been separated into 4 and 3 pieces respectively to allow for easier 3d printing, especially on smaller printers. The top pieces are also split to make painting easier.
The bottom parts have small peg holes, allowing you to use ~1.5mm rods to align them before they are glued down in place.
The windscreen and 2 side windows are also their own pieces which can be 3d printed in translucent/natural filament. What is shown in our images above show these parts spray painted with clear blue paint to give the cartoon accurate tint. This will also allow for ligtning lighting to be added.
Inside this model, you can print and place the console and seats (as were seen in the original cartoons) or remove them if you want to load up a fellow small autobot car in alt mode. A removable tailgate will close up Wheeljack's alt mode rear.
This model is not to be uploaded or sold in any form and is intended for personal use only.
Support us on Patreon - https://www.patreon.com/FunbieStudios
3D concepts, design & development, fabrication, post-processing, with a focus on open sharing, education and community.
Support Us on Patreon - https://www.patreon.com/FunbieStudios
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!