Alphabet Train

Small Alphabet Train, learn and play!

All letters can be vertically print, no supports needed, they're also included on the models (except locomotive roof which can be difficult even if I succeeded to print it without support). Be carreful when you removed the supports (see prints parameters).

The train consist of:
- All letters from A to Z
- 1 locomotive
- 1 wheel
- 1 base (for designers who wants to make modifications)

For the axis, you can use a piece of filament (diameter 1.75mm) 35mm lenght, put it inside the car and put the wheel. Then, with a hot spring (ex: lighter): lightly burn the ends and flatten then. WARNING: this operation must be made by an adult!!

An other solution is to use filament (1.75mm ) or a toothpick and use glue to fix the wheels.

About 1h30 is needed to print 1 wagon and 4 wheels.

Prints parameters:

Print with a Dagoma Discovery 200
- PLA Filament
- 0.2mm (0.15 for the locomotive)
- Density 0% can be OK, but I advise to use 17% because some letters are weak, specially when supports removed.