Sombra Overwatch - Action Pose Special Edition - Blizzard Entertainment

When you download the product, you will have 8 Stl Files. ( Total 450 Mb )

1-Base
2- Sombra Full Figure
3- Full Figure With Base

Disassembled Edition

1- Sombra Upper Body With Head
2- Sobra Lower Body With Legs
3- Sombra Right Arm With Weapon
4- Sombra Left Arm
5-Base

Suggestion: If you are going to press it at once, a good support setting will be sufficient.
If you are going to print in pieces, gluing retouching may give better results.

Note: Base fill must be more than model fill. It is required to prevent it from falling when mounted on the Model Base.
If the Sample Base Fill rate is 40%, the Model Fill rate should be between 10 and 30%.

• Follow me for more models
• You can send me a message about the model or in general.

You can also reach me via social media.

Twitter : https://twitter.com/YunusKullebi
Instagram: https://www.instagram.com/yunuskullebi/

Print Temperature : : 200
Table Temperature : 60
Layer Height : 0.2 mm
Intıal Layer Heigt : 0.2 mm
Wall Line Count : 0.4 mm
Fill Density : % 20

Support Settings

Support Stracture : Tree
Maximum Branch Angle : 60
Branch Diameter : 3
Trunk Diameter : 16
Branch Diameter Angle : 5
Support Placement : Everywhere
Prefferred Branch Angle : 25
Diameter İncrase to Model : 1
Minimum Height to Model : 3
Intial Layer Diameter : 6
Branch Destinty : 20
Tip Diameter : 0.8
Limit Branch Reach : Yes
Optimal Branch Range : 30
Rest Preference : On Model if Required
Support Overhang Angle : 55
Support Pattern : Gyroid
Connect Support Lines : Yes
Support Density : 5
Support Line Distance : 8
Intial Layer Support Line Distance :8
Support interface Thicknes : 1.2